What's in the Box:

• 1x Damper

• 1x Bracket

• 1x Coupling Nut

• 2 x Screw ISO 7380 M8x25 A2
• 2 x Washer DIN 125A 8,4 PA6 
• 1 x Nut DIN 985 M8 A2

Damper installation

Tools required:

- Phillips Screwdriver (NOT INCLUDED)- Wrench 8/10/13 mm (NOT INCLUDED)

- H5 Hex key (NOT INCLUDED)

- H4 Hex key (NOT INCLUDED)  

1. Install the damper bracket in the correct position using the highlighted screw.

2. Unscrew the selected nuts.

3. Screw in the highlighted screws by 3 turns to increase the height of the threaded part for installing the bracket.

4. Install the bracket and secure it with the same nuts.

5. Remove the highlighted screw.

6. Screw the coupling nut into the hole.

7. Install the damper and secure it with screws and nuts.

Important! The damper must not limit the pedal travel. In case of discrepancy, go back to point 1 and adjust the position of the bracket.

8. Adjust the force (counterclockwise - decrease the force; clockwise - increase the force).

Troubleshooting

If you are experiencing any issues or have further questions, please create a support ticket and our support team will assist you ASAP!

https://support.virpil.com/

Regards,

VIRPIL Controls Team