What's in the Box:

• 1 x VPC Rotor TCS Base

• 1 x Limiter-30 (preinstalled)

• 1 x Limiter-40

• 1 x Limiter-50

• 4 x Cable Clips

• 4 x Bolt ISO 8677 М5х16 A2

• 4 x Washer DIN 934 М5х16 A2 

• 4 x Nut DIN 9021 5,3 A2

• 1 x VPC DUAL USB - XS9 Cable (5,0m) 

Setting the Travel Range

Tools required:

• H2.5 Hex Key (NOT INCLUDED)
  
• H5 Hex Key (NOT INCLUDED)
  
  

1. Unscrew the highlighted screws and remove the cover of the base.

2. Unscrew the two marked screws to remove the installed cam plate and replace with the desired one.

Force Adjustment

Tools required:

• H5 Hex Key (NOT INCLUDED) 
   

1. Remove the rubber access port covers from the top and bottom of the base.

2. Adjust the resistance with the highlighted screws using the hex wrench and reinsert the plugs in place.

IMPORTANT!  For the correct operation of the mechanism; when adjusting damper the upper and lower screws must be adjusted equally. 

Installing the Bracket

Tools required:

• Phillips Screwdriver (NOT INCLUDED)
  
• H5 Hex Key (NOT INCLUDED)
   

1. Remove the highlighted screw.

2. Remove the 4 highlighted screws under the washer and detach the bracket from the base.

3. Connect the bracket to the base according to one of the options below:

Option #1

Option #2

Option #3

4. The mounting holes on the bracket can be used to attach to an existing cockpit setup or to the VPC Chair Mount - Collective Base Adapter.

Connecting the VPC Rotor TCS Base

ATTENTION: Please ensure the correct cable-port connection is made (e.g. PC USB cable to device port labelled "USB"). Incorrect cable connection can lead to non-warranty damage to the device electronics.  

Insert the clips until they click intoplace on the bracket and route the cable through them.

IMPORTANT! Use VPC Software to configurate the device

Troubleshooting

Please visit the VIRPIL Controls support portal for troubleshooting advice. If you are still experiencing issues or unable to find answers to your specific question, please create a ticket on our support portal!

https://support.virpil.com