What's in the Box:

  • 1 x VPC Flightstick Z-Extension

  • 1 x Hex Key H5
  • 1 x Hex Key H2.5


Attaching the Extension


Before attaching your Z-Extension, ensure that the locking screws are flush with the screw collar.

1. Pull the cable from the extension by 2-3 cm.

2. Use the arrows located on the cable connector and extension socket to correctly orient the pins. Incorrect orientation will result in damage to the connectors.

3. Lightly tighten the screw collar and set the desired angle offset before hand tightening fully. 

4. Use the included H2.5 Hex Key to tighen the highlighted screws on the collar. This will prevent the extension  from unlatching during use. 



5. Use the Hex Key H5 to set the desired angle.




Attaching VPC Alpha Grip


Before attaching your grip, ensure that the locking screws are flush with the screw collar. 

1. Pull the cable from the grip by 2-3 cm. 

2. Use the arrows located on the cable connector and grip socket to correctly orient the pins. Incorrect orientation will result in damage to the connectors. 

3. Lightly tighten the screw collar and set the desired angle offset before hand tightening fully. 

4Use the included H2.5 Hex Key to tighten the highlighted screws on the collar. This will prevent the grip from unlatching during use. 



Attaching VPC Hawk-60 Grip

1. Gently pull the cable out of the handle by 2-3 cm.

2. Use the arrows highlighted in the image below, orient the connectors and firmly insert the plug. 

3. Lightly tighten the screw collar and set the desired angle offset before hand tightening fully. 

IMPORTANT! Use VPC Software to configure the device 


Troubleshooting


Please visit the VIRPIL Controls support portal for troubleshooting advice. If you are still experiencing issues or unable to find answers to your specific question, please create a ticket on our support portal!


https://support.virpil.com