What's in the Box:

• 1 x VPC MongoosT-50CM3 Throttle
• 1 x USB Cable
• 5 х Detent Plate Sets
• 3 х Button Inlay Sheets

Tools required:

• Wrench 10 mm (NOT INCLUDED)
  
  
• H2.5 Hex hey (NOT INCLUDED)
  

To adjust the axis lever force, remove the bottom cover by removing the highlighted screws:

Adjust the highlighted nuts with an 10 mm spanner to adjust each lever. Hold the lever steady from the topside while adjusting the nuts:

Installing Detents

Tools required:

• H2 Hex hey (NOT INCLUDED)

1. Remove the highlighted screws and select the desired detent plates from the table above.

2. Adjust the position of the detent plates to your preference before tightening the screws

Mounting to the VPC Desk Mount V3

Tools required:

• Wrench 10 mm (NOT INCLUDED)
   
• H4 Hex key (NOT INCLUDED)
  

1. Removed the highlighted screws and detach the leg supports.

2. Remove the lower bracket from the VPC Desk Mount by removing the highlighted screws and nuts.

3. Position the VPC Desk Mount Adapter - MT-50 Throttle in place of the lower bracket.

4. Secure the adapter with the same screws and nuts.

5. Attach the VPC MongoosT-50CM3 Throttle to the adapter using the М5х12 screws.

Attention! When fixing the device to a surface using holes with M5 nuts in the bottom cover, the screw-in depth should not exceed 12 mm. Failure to do so may damage the internal architecture of the device. 

 Select the correct screw length! 

Device Connection

ATTENTION: Do not apply excessive force when connecting cables. The USB (4 Pin) and AUX/OUT (5 Pin) connectors are physically incompatible to prevent cross-wiring.  Ensure you are using the correct cable each connector to prevent permanent damage. 

IMPORTANT! Use VPC Software to configurate the device

Inserting Button Inlays

Troubleshooting

Please visit the VIRPIL Controls support portal for troubleshooting advice. If you are still experiencing issues or unable to find answers to your specific question, please create a ticket on our support portal!

https://support.virpil.com