What's in the Box:

• 1 x VPC Keyboard Mount 

• 1 x Swivel Adapter

• 1 x Tilt Adapter

• 4 x M6 x 12mm Bolt
• 4 x M4 x 10mm Screw
• 4 x M6 Nut
• 4 x M4 Nut

Installing the VPC Keyboard Mount Adapter

Tools required:

• Wrench 7 mm (NOT INCLUDED)
• Wrench 10 mm (NOT INCLUDED)
  
• H2.5 Hex hey (NOT INCLUDED)
• H5 Hex key (NOT INCLUDED)
  

Variant #1

1. Attach the swivel adapter to the keyboard mount as shown in the figure below.

2. Fasten the adapter with the M4 x 10mm screws and M4 nuts.

3. Align the swivel adapter with the mounting slot on the VPC Desk Mount.

4. Attach the swivel adapter to the VPC Desk Mount using the  M6 x 12mm bolts M6 nuts.

5. Slightly loosen the highlighted clamps.

6. Move the lower bracket downwards and insert your keyboard.

7. Raise the lower bracket until the upper bracket grips the keyboard securely and tighten the hand clamps. 

8. The angle can be adjusted by loosening the highlighted bolt. 

Variant #2

1. Loosen the hand clamps on the Keyboard holder.

2. Remove the lower bracket.

3. Align the lower bracket to the swivel adapter.

4. Attach the lower bracket using the M4 x 10mm screws and M4 nuts.

5. Attach the swivel adapter to the VPC Desk Mount as in Variant #1 (steps 3 and 4). 

6. Rotate the bracket by loosening the highlighted bolt.

Variant #3

1. Align the keyboard holder to the tilt adapter as shown.

2. Attach the keyboard holder using the M4 x 10mm screws and M4 nuts.

3. Align the tilt adapter with the mounting slot on the VPC Desk Mount. 

4. Attach the tilt adapter via the 2 top most mounting points using the M6 x 12mm bolts and M6 nuts, do not fully tighten yet.

5. Loosely attach the lower M6 x 12mm bolts and M6 nuts.

6. Set the desired tilt angle and fully tighten the M6 nuts.

7. Install your keyboard as shown on Variant #1 (steps 5-7). 

Variant #4

1. Detach the lower bracket as shown on Variant #2 (steps 1 and 2).

2. Align the lower bracket to the tilt adapter as shown.

3. Attach the lower bracket to the tilt adapter using the M4 x 10mm screws and M4 nuts.

4. Attach the adapter the VPC Desk Mount as shown on Variant #3 (steps 3-6). 

Layout Examples

VPC Keyboard Mount Adapter is compatible with the VPC Desk Mount Mini/S/L

Troubleshooting

Please visit the VIRPIL Controls support portal for troubleshooting advice. If you are still experiencing issues or unable to find answers to your specific question, please create a ticket on our support portal!

https://support.virpil.com