Desk Mount Adapter - Control Panel. User Manual

Modified on Thu, 3 Oct at 2:19 PM

What's in the Box:

  • 1 x Mount Bracket
  • 1 x Joining Adapter
  • 4 x Joining Plates
  • 2 x Central Joining Plate
  • 4 x Bolt М6х12
  • 4 х Nut М6
  • 4 x Bolt М5х12
  • 4 х Nut М5
  • 4 x Bolt DIN 912 М5х12


Installing Your Control Units


Tools required:

  • 8 мм Wrench (NOT INCLUDED)
  • 10 мм Wrench (NOT INCLUDED)  

  • H2.5 Hex Key (NOT INCLUDED)
  • H4 Hex Key (NOT INCLUDED)
  • H5 Hex Key (NOT INCLUDED)


Variant #1

1. Unscrew the highlighted screws and remove the inner desk legs from each device.

2. Remove the 6 x highlighted screws from the connecting side of both devices.

3. Install the joining plates on one of the devices as shown in the figure below and re-attach the screws.

4. Slide the second device into the joining plates and re-attach the screws as shown.


Variant

#2


1. Remove the desk legs from both devices. 


2. Remove the 5 x highlighted screws from the connecting side of both devices. 

3. Install the joining plates on one of the devices as shown in the figure below and re-attach the screws. 

4. Attach the second device as shown. 

5. Attach the joining plate to the MongoosT-50 Throttle Desk Mount Adapter with M5x12 screws and M5 nuts, adjust to your desired position and secure. 

 6. As shown in the figure below, mount the combined devices to the joining plate using DIN 912 M5x12 screws.


Variant #3


1. Disconnect the control panel supports and reorient the connectors as shown here (step 1-4).

2. Combine the control units as shown in Option 2 (step 2-4).

3. Attach the joining plate to the mount bracket using M5x12 screws and M5 nuts.


 
4. Install the mount bracket with the joining plate to the VPC Desk Mount V3 - L / S / Mini with M6x12 screws and M6 nuts.


5. As shown in the figure below, mount the combined control units to the joining plate using DIN 912 M5x12 screws.




Variant #4


1. Disconnect the control panel supports and reorient the connectors as shown here (step 1-4).


2Attach the mount bracket to the control panel using DIN 912 M5x12 screws.

3. Install the mount bracket to the VPC Desk Mount V3 - L / S / Mini with M6x12 screws and M6 nuts.



Troubleshooting


Please visit the VIRPIL Controls support portal for troubleshooting advice. If you are still experiencing issues or unable to find answers to your specific question, please create a ticket on our support portal!


https://support.virpil.com



Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article